Atlanta Outdoor Kitchen Bar Construction in Sandy Springs, GA - Costs, Quotes & Local Notes

An outdoor bar is two jobs in one structure: a counter run built to bar height, and a small commercial beverage system with water, power and a drain.

Get matched freeUse the free tools

A custom outdoor bar is published as a built-in kegerator, wine or beverage fridge, insulated ice bin, prep sink, under-bar LED lighting and bartop seating. A bar-height counter run on its own is published at $180-320/lf, against $250-450/lf for a masonry block island with stucco finish and $450-900/lf for a kitchen under a pergola or patio cover, and the site-wide project band is 15,000 and 35,000. The dimensions are published too: a bartop overhang of 18-24 inch, a standard bartop height of 42 inches, a stool height of 30 inches, 24 inches of width per bar stool, and 12-15 inches of knee clearance under the overhang. Atlanta Outdoor Kitchens is an independent matching service, not a provider - we route your request to licensed local builders.

What it costs in Sandy Springs

JobPublished 2026 range
Built-in gas grill, installed1,500 - 5,000
Pizza oven, installed1,000 - 8,000
Outdoor-rated refrigerator800 - 3,500
Sink with plumbing300 - 2,000
Gas line run from the meter400 - 2,000
Low-voltage lighting package500 - 1,500
Running gas, water and electric lines together2,000 - 5,000
Underground line runs and trenching500 - 2,000
Permit allowance$75 - $400
Removal or demolition, per unit25 - 60

What an outdoor bar build actually involves

The published equipment list for a custom outdoor bar is shorter than a full kitchen and more demanding in one respect: almost everything on it uses water, power or gas.

Published equipment: a built-in draft beer system with a single or dual tap and a hidden CO2 tank and lines; an outdoor-rated undercounter refrigerator, dual-zone where wine is involved; an insulated drop-in ice chest with a drain line to prevent standing water; a small bar sink; and under-bar accent lighting. Bartop seating completes it, with a granite, concrete or butcher block surface and an overhang of 18-24 inches for the stools.

ElementPublished dimensionWhy it matters
Bartop overhang18-24 inchRoom for legs and knees at the bar face
Standard bartop height42 inchesSets the stool and the counter relationship
Stool height30 inchesMatched to a 42 inch bartop
Width per bar stool24 inchesDecides how many seats the run actually holds
Knee clearance12-15 inches under the overhangThe difference between a seat and a shelf
Work surface36 inches for the cooking zoneRaised to 42 inches for the social zone

Two published planning rules follow from those numbers. Allow 24 inches of width per bar stool, and decide the stool height before the counter is fabricated, not after - a 42 inch bartop with 24 inch stools is a standing shelf with a view.

Published cost bands and what the equipment adds

A bar is often quoted as its own line because it is measured and priced differently from a cooking counter.

Line itemPublished band
Bar-height counter run only, no appliances$180-320/lf
Typical project range15,000 and 35,000
Full build with sink, fridge, pizza oven and stone counters20,000 and 50,000
Modular stainless cabinets with stone top$350-700/lf
Masonry block island with stucco finish$250-450/lf
Kegerator or beverage center, installed700 - 2,500
Outdoor-rated refrigerator, installed800 - 3,500
Sink with plumbing, installed300 - 2,000

The published lifespan and upkeep figures for a bar-height counter run differ from the rest of the list in a way worth noting: 20 yrs on the published lifespan table, a short re-seal interval of 2 yrs, and annual maintenance published at 120 - the lowest of the published rates, because a bar carries no cooking heat and no grill grease.

Cost drivers stay the same across the niche: appliances, countertop material, and utility runs are the big-ticket items, prices vary by 30 to 40 percent for the same layout based on appliance brands and stone selection, and underground line runs and trenching add 500 to 2,000 that many quotes leave out. Running gas, water and electric lines to the zone is published at 2,000 to 5,000.

Draft systems, CO2 and the routing drawing

This is the published test for whether a bar quote is real. A CO2 tank, a glycol-cooled draft line and an ice bin are not appliances that sit in a cabinet; they are a small system with a heat load, an exhaust path and a drain.

Published rules: CO2 needs a dedicated, ventilated home, and draft systems require a compressor unit with enough air around it to shed heat. Wine fridges use UV-protected glass. And the guidance to homeowners is unusually direct - ask each builder to show the drain and CO2 routes on a drawing, because a quote listing a kegerator and ice bin without a routing drawing has not priced them yet.

SystemPublished requirementWhat it needs on the drawing
Draft beer systemCompressor with enough air around it to shed heatVentilation path and line run from the keg space to the tap
CO2 tankA dedicated, ventilated homeTank location, vent and a way to change it without dismantling the bar
Ice binInsulated, drop-in, with a drain lineDrain route that prevents standing water
Wine or beverage fridgeOutdoor-rated, dual-zone, UV-protected glassDedicated circuit and clearance for the door swing

Published zoning advice follows: separate a dry prep zone from a wet bar zone, keep the ice bin on the wet side and the glassware on the dry side, and keep the appliance doors off the bar face - a fridge opening into the seating run is a design problem, not an install problem.

Local note for Sandy Springs

Same Piedmont ground as the rest of the metro: the Cecil series, a sandy loam surface over red kaolinitic clay with water table deeper than 60 in and low shrink-swell but medium surface runoff (USDA-NRCS Cecil OSD: https://soilseries.sc.egov.usda.gov/OSD_Docs/C/Cecil.html). On the sloped lots common on Sandy Springs' north side, plan the patio and any masonry counter so storm water sheets past the structure to a defined outlet, and keep post footings below the seasonal wet-dry zone.

Sandy Springs does not run its own water system: the city's own utilities page names the Atlanta Department of Watershed Management as the water provider and the party that handles billing for both water supply and sewer, and tells residents to call the ATL311 centre on 404-546-0311 first for billing questions (https://sandyspringsga.gov/utilities). Because the supply is Atlanta's Chattahoochee River system, the applicable water-quality data are in Atlanta DWM's Consumer Confidence Report rather than in any separate Sandy Springs report (https://atlantawatershed.org/water-quality-reports/). Sanitary sewer in Sandy Springs is a third party again - Fulton County maintains it (404-612-6830).

Utility accounts: City of Atlanta Department of Watershed Management · 404-546-0311

Checking a quote in Sandy Springs

Frequently asked questions

How much does an outdoor bar cost in Atlanta?

A bar-height counter run with no appliances is published at $180-320/lf, against $250-450/lf for a masonry block island with stucco finish and $350-700/lf for modular stainless cabinets with a stone top. Equipment adds its own published ranges: a kegerator or beverage center 700 - 2,500 installed, an outdoor-rated refrigerator 800 - 3,500, and a sink with plumbing 300 - 2,000. The site-wide project band is 15,000 and 35,000.

What bartop height and clearance do I need?

The published figures are a standard bartop height of 42 inches with a stool height of 30 inches, a bartop overhang of 18-24 inch, 24 inches of width per bar stool, and knee clearance of 12-15 inches under the overhang. The cooking zone stays at a standard 36 inch counter, with the 42 inch surface reserved for the social side.

Does an outdoor bar need plumbing and a drain?

A sink does: the published requirement is hot and cold running water with an outdoor-rated faucet on a dedicated water line and proper drainage, not just a garden hose connection, and an insulated ice bin needs a drain line to prevent standing water. The slab should slope away from the structure and include a floor drain if the build has a sink or ice maker, because poor drainage leads to standing water, moss, and rusted appliance bases.

Related pages

Ready to Get Started?

Free estimates from trusted Atlanta outdoor kitchen pros.