A custom outdoor bar is published as a built-in kegerator, wine or beverage fridge, insulated ice bin, prep sink, under-bar LED lighting and bartop seating. A bar-height counter run on its own is published at $180-320/lf, against $250-450/lf for a masonry block island with stucco finish and $450-900/lf for a kitchen under a pergola or patio cover, and the site-wide project band is 15,000 and 35,000. The dimensions are published too: a bartop overhang of 18-24 inch, a standard bartop height of 42 inches, a stool height of 30 inches, 24 inches of width per bar stool, and 12-15 inches of knee clearance under the overhang. Atlanta Outdoor Kitchens is an independent matching service, not a provider - we route your request to licensed local builders.
What it costs in Alpharetta
| Job | Published 2026 range |
|---|---|
| Built-in gas grill, installed | 1,500 - 5,000 |
| Pizza oven, installed | 1,000 - 8,000 |
| Outdoor-rated refrigerator | 800 - 3,500 |
| Sink with plumbing | 300 - 2,000 |
| Gas line run from the meter | 400 - 2,000 |
| Low-voltage lighting package | 500 - 1,500 |
| Running gas, water and electric lines together | 2,000 - 5,000 |
| Underground line runs and trenching | 500 - 2,000 |
| Permit allowance | $75 - $400 |
| Removal or demolition, per unit | 25 - 60 |
What an outdoor bar build actually involves
The published equipment list for a custom outdoor bar is shorter than a full kitchen and more demanding in one respect: almost everything on it uses water, power or gas.
Published equipment: a built-in draft beer system with a single or dual tap and a hidden CO2 tank and lines; an outdoor-rated undercounter refrigerator, dual-zone where wine is involved; an insulated drop-in ice chest with a drain line to prevent standing water; a small bar sink; and under-bar accent lighting. Bartop seating completes it, with a granite, concrete or butcher block surface and an overhang of 18-24 inches for the stools.
| Element | Published dimension | Why it matters |
|---|---|---|
| Bartop overhang | 18-24 inch | Room for legs and knees at the bar face |
| Standard bartop height | 42 inches | Sets the stool and the counter relationship |
| Stool height | 30 inches | Matched to a 42 inch bartop |
| Width per bar stool | 24 inches | Decides how many seats the run actually holds |
| Knee clearance | 12-15 inches under the overhang | The difference between a seat and a shelf |
| Work surface | 36 inches for the cooking zone | Raised to 42 inches for the social zone |
Two published planning rules follow from those numbers. Allow 24 inches of width per bar stool, and decide the stool height before the counter is fabricated, not after - a 42 inch bartop with 24 inch stools is a standing shelf with a view.
Published cost bands and what the equipment adds
A bar is often quoted as its own line because it is measured and priced differently from a cooking counter.
| Line item | Published band |
|---|---|
| Bar-height counter run only, no appliances | $180-320/lf |
| Typical project range | 15,000 and 35,000 |
| Full build with sink, fridge, pizza oven and stone counters | 20,000 and 50,000 |
| Modular stainless cabinets with stone top | $350-700/lf |
| Masonry block island with stucco finish | $250-450/lf |
| Kegerator or beverage center, installed | 700 - 2,500 |
| Outdoor-rated refrigerator, installed | 800 - 3,500 |
| Sink with plumbing, installed | 300 - 2,000 |
The published lifespan and upkeep figures for a bar-height counter run differ from the rest of the list in a way worth noting: 20 yrs on the published lifespan table, a short re-seal interval of 2 yrs, and annual maintenance published at 120 - the lowest of the published rates, because a bar carries no cooking heat and no grill grease.
Cost drivers stay the same across the niche: appliances, countertop material, and utility runs are the big-ticket items, prices vary by 30 to 40 percent for the same layout based on appliance brands and stone selection, and underground line runs and trenching add 500 to 2,000 that many quotes leave out. Running gas, water and electric lines to the zone is published at 2,000 to 5,000.
Draft systems, CO2 and the routing drawing
This is the published test for whether a bar quote is real. A CO2 tank, a glycol-cooled draft line and an ice bin are not appliances that sit in a cabinet; they are a small system with a heat load, an exhaust path and a drain.
Published rules: CO2 needs a dedicated, ventilated home, and draft systems require a compressor unit with enough air around it to shed heat. Wine fridges use UV-protected glass. And the guidance to homeowners is unusually direct - ask each builder to show the drain and CO2 routes on a drawing, because a quote listing a kegerator and ice bin without a routing drawing has not priced them yet.
| System | Published requirement | What it needs on the drawing |
|---|---|---|
| Draft beer system | Compressor with enough air around it to shed heat | Ventilation path and line run from the keg space to the tap |
| CO2 tank | A dedicated, ventilated home | Tank location, vent and a way to change it without dismantling the bar |
| Ice bin | Insulated, drop-in, with a drain line | Drain route that prevents standing water |
| Wine or beverage fridge | Outdoor-rated, dual-zone, UV-protected glass | Dedicated circuit and clearance for the door swing |
Published zoning advice follows: separate a dry prep zone from a wet bar zone, keep the ice bin on the wet side and the glassware on the dry side, and keep the appliance doors off the bar face - a fridge opening into the seating run is a design problem, not an install problem.
Local note for Alpharetta
Alpharetta sits on the same Cecil/Appling Piedmont clay, with red kaolinitic subsoil rated low shrink-swell and well drained but with medium surface runoff (USDA-NRCS Cecil OSD: https://soilseries.sc.egov.usda.gov/OSD_Docs/C/Cecil.html). Alpharetta's residential building procedures separately require site walls, walks and drives to be site-specifically designed by a Georgia P.E. and require a soil erosion and sediment control plan, which is worth pricing into footing, retaining and hardscape work (https://www.alpharetta.ga.us/departments/community-development/inspections-code-enforcement).
Alpharetta's own website states that the City of Alpharetta does not provide water and sewer service and directs residents to the Fulton County Water Department on 404-612-6830 (https://www.alpharetta.ga.us/services?contentId=e7b4824f-ecda-44eb-b6d8-66d5b1528240). Fulton County Public Works supplies north Fulton from the Chattahoochee River - the Lake Lanier-Chattahoochee system feeds the Atlanta-Fulton County raw water reservoir - and the county's own source-water assessment rated the Chattahoochee watershed a 'medium risk' for potential pollutant loads (https://www.fultoncountyga.gov/services/water-services/water-quality). That same county page documents a recurring seasonal water-quality event residents should expect: a harmless 'musty' or 'earthy' taste and odour each spring and autumn when the reservoir layers turn over, which the county treats with activated carbon at the Tom Lowe Water Plant.
Utility accounts: Fulton County Department of Public Works (Water Services) · 404-612-6830
Checking a quote in Alpharetta
- Is the quote itemised for the island, the countertop, the appliances and the connections, or is it one lump sum?
- Who pulls the gas and electrical permits, and is that cost in the quote?
- Is the countertop templated after the island is built, and what happens if the measurement is wrong?
- Are the appliances supplied by the contractor or by me, and who handles their warranty?
- What is the workmanship warranty on the masonry and the countertop, separately from the appliance warranties?
Frequently asked questions
How much does an outdoor bar cost in Atlanta?
A bar-height counter run with no appliances is published at $180-320/lf, against $250-450/lf for a masonry block island with stucco finish and $350-700/lf for modular stainless cabinets with a stone top. Equipment adds its own published ranges: a kegerator or beverage center 700 - 2,500 installed, an outdoor-rated refrigerator 800 - 3,500, and a sink with plumbing 300 - 2,000. The site-wide project band is 15,000 and 35,000.
What bartop height and clearance do I need?
The published figures are a standard bartop height of 42 inches with a stool height of 30 inches, a bartop overhang of 18-24 inch, 24 inches of width per bar stool, and knee clearance of 12-15 inches under the overhang. The cooking zone stays at a standard 36 inch counter, with the 42 inch surface reserved for the social side.
Does an outdoor bar need plumbing and a drain?
A sink does: the published requirement is hot and cold running water with an outdoor-rated faucet on a dedicated water line and proper drainage, not just a garden hose connection, and an insulated ice bin needs a drain line to prevent standing water. The slab should slope away from the structure and include a floor drain if the build has a sink or ice maker, because poor drainage leads to standing water, moss, and rusted appliance bases.
